Explain the difference between relative dating and radiometric dating

What is the difference between relative dating and radiometric dating?

Pre/Post-Test Key

Scientists combine several well-tested techniques to find out the ages of fossils. The most important are Relative Dating, in which fossils and layers of rock are placed in order from older to younger, and Radiometric Dating, which allows the actual ages of certain types of rock to be calculated. Fossils are found in sedimentary rocks that formed when eroded sediments piled dating sites vero beach fl in low-lying places such as river flood plains, lake bottoms or ocean floors.

Sedimentary rock typically is layered, with the layers derived from different periods of sediment accumulation. Almost any place where the forces of erosion - or road crews - have carved through sedimentary rock is a good place to look for rock layers stacked up in the exposed rock face. These rock layers formed from sediments deposited in a lake. Photo courtesy of Rod Benson, www. When you look at a layer cake, you know that the layer at the bottom was the first one the baker put on the plate, and the upper ones were added later.

In the same way, geologists figure out the relative ages of fossils and sedimentary rock layers; rock layers, and the fossils they contain, toward the bottom of a stack of sediments are older than those found higher in the stack. Until the middle of the last century, "older" or "younger" was the best scientists could do when assigning ages to fossils.

There was no way to calculate an "absolute" age in years for any fossil or rock layer. But after scientists learned that the nuclear decay of radioactive explain the difference between relative dating and radiometric dating takes place explain the difference between relative dating and radiometric dating a predictable rate, they realized that the traces of radioactive elements present in certain types of rock, such as hardened lava and tuff formed from compacted volcanic ashcould be analyzed chemically to determine the ages, in years, of those rocks.

Putting Relative and Radiometric Dating Together. Once it was possible to measure the ages of volcanic layers in a stack of sedimentary rock, the entire sequence could be pinned to the absolute time scale. In the Wyoming landscape shown below left, for example, the gray ash layer was found to be 73 explain the difference between relative dating and radiometric dating years old. This means that fossils in rock layers below the tuff are older than 73 million years, and those above the tuff are younger.

Fossils found embedded within the ash, including the fossil leaves shown below right, are the same age as the ash: Ash layers from ancient volcanic eruptions are found in many sedimentary rock deposits. To learn more about dating fossils, follow this link and click the yellow "Dating Methods" tab at the bottom of the web page. How do we know the ages of fossils and fossil-bearing rocks? Fossil leaves embedded in ash.

Creation v. Evolution: How Carbon Dating Works

Add a comment

Your e-mail will not be published. Required fields are marked *